|
Windows 2000 Dial-up Configuration |
| Enter your Dial-up configuration setup by clicking. . . Start | Settings |  |
| Right click on the icon for your dial-up connection to Impulse then select "Properties". |
|
 |
| Enter the local dial-up number from our list, then click "Configure." |
|
 |
| Compare your settings to those below, change as required, click "OK" when finished. |
|
 |
| We recommend the following settings on your options tab, but you may adjust them to fit your working style. (Do no check "Include Windows logon domain") |
|
 |
| Leave the default settings on the security tab. | |
 |
| Verify you have PPP selected on the networking tab, then click "Settings." |
|
 |
| Only check "Enable software compression" then click "OK". |
|
 |
| Highlight TCP/IP then click "Properties". | |
 |
| Match your settings to ours then click "Advanced." | |
 |
| Both boxes should be checked on the General tab. | |
 |
| Match your settings to ours on the "DNS" tab. | |
 |
| Leave the default setting on the "WINS" tab. | |
 |
| Highlight "IP Security" then click ""Properties." | |
 |
| Check "Do not use IPSEC" then click "OK" three times | |
 |
| Leave the default settings for the "Options" tab then click "OK." |
|
 |
| Close the Network and Dial-up Connections window. If you need to configure a mail client go to our Screenshots page. Otherwise, you're finished! |